Please read and save these instructions.
PACKAGE CONTENTS
Assembly and Installation
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS.
CAUTION: Safe for outdoor operation.
WARNING
or bulb protector.
WARNING: Install in accordance with all local codes and ordinances.
Only for use with low voltage power units with a maximum output rating of 12V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTION.
ETL LISTED UNDER MODEL # L08557.
1
Attaching and installing the light
WARNING: Never push the fixture into the ground by the light (A) or use a
hammer to insert the spike (B) into the ground.
Carefully remove the fixture from its protective packaging.
Attach spike (B) and light (A) together by turning them
anti clockwise.
C
A
B
C
A
B
Part
Description
A
Light
B
Spike
C
Connector
2
Connecting the wires
WARNING: The wire connector (C) contacts have sharp edges for piercing the
main low-voltage cable. To avoid injury, do not touch the metal contacts.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
CAUTION: The wire from the low-voltage power unit shall be 12-18 AWG type
underground low energy circuit cable or SPT2W.
IMPORTANT:
•
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6 in. (15.24 cm).
•
Align the low-voltage wire and fit it into the connector bottom
half as shown below.
Press the top half of the connector into the bottom half until it clicks
into place and is secure. This will pierce the low voltage wire and
connect the light to the transformer.
Test the connection by plugging in the transformer to see if the light
turns on. If it does, unplug the transformer and continue the install-
ation. If it does not, unplug the transformer and check the connec-
tion between the transformer and low-voltage wire, reinstall the
connector, and ensure power is available to the outlet you are using.
Once the connection is secure, repeat the process for the remaining
lights.
Once all lights are connected, it is recommended to wrap each con-
nector with electrical tape for additional protection.
After all fixtures are installed, turn on the transformer by plugging it
into an outlet.
Note: If you want to install this with your existing low-voltage lighting
system, skip step 4 and instead plug the lights into your existing
1
8AWG to 12AWG SPT-2W wiring.
Caution Be careful ! The wire stabs are very sharp !
- 1 -
Item #1006 695 203
Model #L08557
Use and Care Guide
RGBW LED SPOT LIGHT
Quantity
3
3
3
Need help?
Do you have a question about the L08557 and is the answer not in the manual?
Questions and answers