(Artcile Number: Receiver01) on the backside of the panel. It needs to be used in conjunction with the Sundirect control system - Smart 1.0/ Smart 1.0Pro or Smartplug (NOT included in the box) - in order to meet the Ecodesign legislation of the EU/EC Directive 2009/125/EC.
• Do NOT attempt to repair the heater by yourself, this will void your warranty. • If the heater has been dropped do NOT operate it and contact your Sundirect dealer to make sure it is free of any damages.
Page 5
• Please note that the heater may discolour with use. This is due to airborne pollution and is not a fault. If you wish to add a picture print to your heater please contact a Sundirect dealer. Do not cover your heater with a picture foil and do not paint or print the heater yourself. This might cause damage to the heating element and will void your warranty.
Page 6
Receiver01 if they are in the same room. 5.3 Extra Safety Protection: The heater is equipped with the Sundirect “Extra Safety Protection” function, which will automatically turn off the heater if it lost the signal from the Smart controller for more than one hour. And it will...
Page 7
Sundirect. • The SC series is a hot temperature infrared heater. It has a surface temperature of 300-350°C when in operation.
Page 8
The mounting kit included in this box contains: Part A: 2x mounting handles Part B: 2x mounting handles Part C: 8x screws Part D: 8x wing nuts Part E: 4x wall/ceiling anchors Step 1: Slide the mounting handles (part A) into the rail on the back of the heater from the opposite side of the cables.
The warranty covers the repair or replacement of the heater only and Sundirect shall not be liable for any other occurring costs such as installation cost or any other consequential losses however incurred. Please note that tampering with or opening the heater in any way will void your warranty.
Page 10
1. Anmerkungen Vielen Dank, dass Sie sich für Sundirect entschieden haben. Wir hoffen Sie sind zufrieden mit der innovativen Technologie und der angenehmen Atmosphere die dieses Produkt zu Ihnen nach Hause bringt. Zu Ihrer eigenen Sicherheit lesen Sie sich bitte diese Betriebsanleitung sorgfältig durch. Falls Sie die Anweisungen in dieser Anleitung nicht befolgen kann die Produktgarantie verfallen.
Page 11
Das Gerät sollte vor Inbetriebnahme unbedingt auf Schäden untersucht werden. Sollte das Gerät oder das Stromkabel in irgendeiner Art und Weise beschädigt sein, benutzen Sie dieses nicht und kontaktieren Sie bitte umgehend einen autorisierten Sundirect Händler zwecks Reparatur oder Ersatz. Reparaturen, Wartungen oder direkte Veränderungen am Gerät dürfen ausschließlich von einem autorisierten Sundirect Händler durchgeführt werden.
Sundirect Infrarotheizungen wurden für 220-240V, 50Hz AC konzipiert, verwenden Sie das Gerät nicht bei abweichender Stromversorgung. 3.4 Wasser Sundirect Infrarotheizungen haben verschiedene Schutzklassen für unterschiedliche Modelle. Bitte versichern Sie sich anhand der technischen Details, dass Ihre Heizung für die Montage in Fruchträumen geeignet ist.
Licht) “P” Knopf AN/AUS-Taste 5.2 Paarung mit Sundirect Smart-Steuerungssystem Schritt1: Stecken Sie den Stecker der Heizung in eine Steckdose ein. Schalten Sie AN/AUS-Taste des Receiver01 an. Drücken Sie die “P” taste zweimal und die Paarungs-Signalleuchte blinkt nun auf. Das Paneel ist nun bereit für die Paarung.
Page 14
Bitte stellen Sie fest, dass es sicher ist das Paneel an der Wand zu installieren. Wir empfehlen Ihnen das Paneel von einem qualifizierten Elektriker oder Sundirect Installateur montieren zu lassen. Die SC-Serie ist ein Hochtemperatur-Infrarotheizstrahler. • Sie hat eingeschaltet eine Oberflächentemp-eratur von 300-350°C.
Page 15
Dieses Montageset enthält folgende Artikel: Part A: 2x Befestigungsgriffe Part B: 2x Befestigungsgriffe Part C: 8x Schrauben Part D: 8x Flügelmuttern Part E: 2x Wandanker Schritt 1: Schieben Sie die Befestigungsgriffe (Part A) in die Schiene auf der Rückseite der Heizung von der gegenüber liegenden Seite der Kabel.
IP44 7. Garantie Sundirect wird Ihre Heizung innerhalb von 5 Jahren und das Steuerungssystem (inkl. Receive01 und Smart 1.0/ Smart 1.0Pro/Smartplug) innerhalb von 2 Jahren nach Kaufdatum reparieren oder neuwertig ersetzen, sollten Produktions- oder Materialschäden festgestellt werden. Im Garantiefall kontaktieren Sie bitte Ihren Sundirect Händler und weisen eine Kaufbestätigung vor.
Page 17
Information requirement for the electric local space heaters Models: SC-Plus + Smart1.0/Smart1.0Pro/Smartplug Item Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space heaters only(Select one) Nominal heat output Pnom 1.8-2.4 manual heat charge control, with...
Need help?
Do you have a question about the SC-Plus and is the answer not in the manual?
Questions and answers