Wind / Unwind Buttons - Red Sea ReefMat 1200 User Manual

Red Sea ReefMat
®
Settings Button - Function
If indicator LED is off (ReefMat Wi-Fi is off): Pressing button for 5
seconds (until double blink) activates Wi-Fi AP mode.
If indicator LED is blinking (ReefMat Wi-Fi is in AP mode): Pressing
button for 5 seconds (until double blink) switches Wi-Fi off.
If indicator LED is on (ReefMat Wi-Fi is connected to a Wi-Fi
network): Pressing button for 5 seconds (until double blink) disconnects
the ReefMat from the network and switches it to Wi-Fi AP mode. (Note:
before disconnecting a ReefMat from a network, delete the ReefMat
from the ReefBeat App via the Device Manager.) Note: All settings are
retained and can be restored when reconnected to the ReefBeat.
Clear Settings: Pressing the button for 15 seconds (until double blink)
deletes all user settings and switches off the Wi-Fi. Complete the reset
process by disconnecting and reconnecting the DC power.
16

Wind / Unwind Buttons

Pressing the wind button will manually advance material from the
dispensing roll and wind (
Pressing the unwind (
from the take-up roll however it is not automatically wound back to
the dispensing roll. This action is primarily to release the tension on the
take-up roll so that it can be easily removed from its normal operating
position.
Note: The direction of rotation of the wind/unwind buttons are set when
selecting the right/left installation of the drive-unit. The default setting
is for right side installation where the buttons will work correctly even
before onboarding to ReefBeat. For left side installation the buttons will
work in the opposite direction until onboarded to ReefBeat.
Settings
) it on to the take-up roll.
) button will manually dispense used material
Wind Unwind