Installation Of The Reefmat - Red Sea ReefMat 1200 User Manual

Red Sea ReefMat
®
Note: This part has a left-hand thread. The pipe can be used before the
sealant is dry. The other side of the universal connector can be
glued to standard 32mm or 1" PVC piping.
Alternatively, the free end of the corrugated hose can also be attached
directly to standard 32mm diameter PVC tubing as used in most Red
Sea Reefer series systems. This join is not under any water pressure,
however it is advisable to use the liquid sealant and secure the
corrugated hose in place with a cable tie.
12
32mm

Installation of the ReefMat

Rotate the Take-up Shaft Locks to the open
position and remove the take up shaft
from the ReefMat Head. Open the front
flap by raising the handle and rotating it
forwards to its horizontal position, remove
the dispensing shaft, remove the front
guide roller, close the flap and secure in
position by lowering the handle.
Remove the ReefMat Head
from the Filter Chamber by
pressing on the side latches
while lifting it up.