Download Print this page

Espressif ESP01 Quick Start Manual page 16

Advertisement

FCC Statement:
Please take attention that changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.
IC Statement:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
ce matériel est conforme aux limites de dose d'exposition aux rayonnements, CNR-102 énoncée dans un
autre environnement.cette eqipment devrait être installé et exploité avec distance minimale de 20 entre le
radiateur et votre corps.
(1) Operational use conditions
Module has professional users use condition limitations, Host product manufacturer please ensure
giving such warning like "Product is limited to professional users use" in your product's instruction.
(2) Antenna used
Antenna
Max. Antenna
Type
Gain
Dipole
3dBi
(3) Labelling Instruction for Host Product Integrator
Please notice that if the FCC and IC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also
display a label referring to the enclosed module. For FCC, this exterior label should follow "Contains FCC
ID: 2AZLQ-ESP01". In accordance with FCC KDB guidance 784748 Labeling Guidelines. For IC, this
exterior label can use wording "Contains IC: 27189-ESP01".
§ 15.19 and RSS-Gen Labelling requirements shall be complied on end user device. Labelling rules for
special device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For E-label, please
refer to §2.935.

Advertisement

loading
Need help?

Need help?

Do you have a question about the ESP01 and is the answer not in the manual?