Specifications - Memphis MM900.6V Manual

Memphis Audio built a 50 year legacy in the audio industry by engineering the highest quality products to produce
the best possible listening experience for our fans and loyal supporters. To fully appreciate our products we
recommend taking the time to read and follow the instructions in this manual. As always, we recommend all the
installations and services to be performed by an authorized Memphis Audio dealer.
For optimal performance, Memphis recommends using only Memphis Connection accessories. Outfitting
your system with properly sized Memphis Connection wire and accessories will dramatically boost your
listening experience and increase the durability of your Memphis Audio products.
Memphis Audio's MM amplifiers are water resistant to protect them from the elements. These units features easy
access top mounted controls protected by a water resistant panel. Do not operate these amplifiers in areas with
increased moisture without the panel properly installed and tightened to create a seal.
Combine with our Memphis Bluetooth Accessories and Memphis Marine speakers for the perfect
rugged solution for marine grade sound wherever you go!
•IPX5 rated
• Removable power terminal
• Removable sealed signal connectors
• Sealed top mount controls
• Extruded aluminum heat sink
• Signal sensing auto turn on
• 12dB/octave butterworth crossovers
• Input select switch
Specifications
RMS Power/CH @ 4
RMS Power/CH @2
RMS Power/CH @ 1
RMS Power/Bridge 4 Ohms
THD
Signal/Noise Ratio
Frequency Response ± 0.5dB
Crossover Frequency (HPF)
Crossover Frequency (LPF)
Dimensions (in)
Input Sensitivity
Low Level
High Level
Crossover Slope
Features
Specifications
MM900.6V
70 x 4 + 200 x 2
90 x 4 + 300 x 2
200 x 2 + 600 x 1
>80dB
10Hz - 36kHz
50 - 1kHz
50 - 250Hz
13.1 x 7.3 x 2
200mV-6V
3V-20V
*Features and Specifications are subject to change without notice.
1
MM900.6V/MM500.4V/MM600.2V
• LED light strip
• Remote bass knob included
• Variable bass boost 0-12dB
• 24dB Infrasonic Filter
• Fully variable crossover
• Protection circuitry against:
Overload/short circuit/thermal/reverse polarity
MM500.4V
-
<1%
10Hz - 25kHz
50 - 250Hz
10.5 x 7.3 x 2
200mV-6V
12dB
MM600.2V
80 x 4
125 x 4
-
250 x 2
<1%
>80dB
10Hz - 25kHz
50 - 1kHz 50 - 1kHz
50 - 250Hz
9.785 x 7.3 x 2
200mV-6V
3V-20V
12dB
200 x 2
300 x 2
-
600 x 1
<1%
>80dB
3V-20V
12dB