Advertisement
3. Attach [a] Main Unit to Angle Grinder. (Some models need [m] Offset Plate between [a] and Angle Grinder)
4. Set [ d / e / f ] Spacer, [c] Flange, and Grinding Cup into Spindle.
5. Tighten the [b]Lock Nut with Wrench.
(Fig.4)
Wrench
Grinding Cup
Angle Grinder
If Diamond Cup is off center, loosen 3 screws with [ i ] Wrench(S) and adjust the position of [a] Main Unit. (Fig.5)
※Re-tighten 3 screws securely after adjustment.
Use the proper Spacer [ d / e / f ] to keep the bottom space 1～5mm under the Grinding Cup,
or it could lead to the leakage of dust at work. (Fig.6)
[d]
[e]
[ f ]
Use proper Spacer.
-2-
[b]
[c]
[ d / e / f ]
[a]
[m]
※Some models ONLY.
Spindle
Screws
1～5mm
Refer to the attached sheet for details.
[ i ]
Fig.4
Fig.5
Fig.6
Advertisement
