Automatic Heating; Temperature Setting - HOMCOM 820-195V70 Assembly & Instruction Manual

1) Connect the power
2) Turn on the power switch
3) Press the control switch or "ON/OFF" key of the remote controller to start up
4) Press the 1000W/2000W button once for the low heat setting 1000W; press twice for the high heat setting
2000W; press three to switch off the heat setting.
5) Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and lower the brightness.
6) Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.

2. Automatic heating

Press "IC" button on the remote controller to start or exit the automatic heating.
The heater displays AUTO symbol at automatic heating status. The heater will adjust the heat settings between
1000W and 2000W automatically according to the room temperature and temperature setting. During a timed
starting process, it is possible to start heating ahead of schedule.
NOTE: Maybe the heater will turn the heating on automatically prior to the set time maximum20
minutes.
3. Setting the day and time
1) Settings are done on the remote controller
▼
2) Press "DATE TIME" button, then press the "▲" or " " key to select the day
3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4)Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5) Press "OK" button to complete

4. Temperature setting

The default set temperature is 20 ℃, press "+" or "-" on the remote controller to set the temperature, which
ranges from 15 to 30℃. And this setting is only for the temperature in the normally mode, not for the temperature
in the timer mode.
NOTE:
The set temperature must be higher than the room temperature for the heat working.
5. Timer setting
1)Description of timer setting
There are up to 10 items for timer setting
Each setting item has its date, power-on time and shutdown time
The max. duration of each setting item is 23 hours 50 minutes
The setting date for each item can be any day or days of a week
The date in each setting item represents the date of power-on time
If the shutdown time of the setting falls on the second day, it is unnecessary to set the date – you just set the
shutdown time
2)Steps to view the timer setting
Press the "TIMER SET" button
Press the "+" or "-" to check the power-on time of the timer one by one.
For checking the shutdown time, press the "▲" button
Press the "+" or "-" to continue viewing
7