Video Remote Control Timer Programming - JVC HM-DH5U Instructions Manual

Video Remote
Control Timer
Programming
•
Turn on the VCR and the TV (and/or Digital Set Top
Box).
•
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
VCR
CABLE
TV /DBS
- b
[AUX]
This VCR can perform analog recording of a program
which is timer-programmed on your Integrated HDTV (or
Digital Set Top Box).
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before inserting
the cassette.
Select analog input location on
the VCR
On the front panel:
Press [CHANNEL +] or [–] to select "L-1" etc.
On the Remote:
a– Press [TV/VCR CH +] or [–] to select "L-1" etc.
b– Press the 'Number' key [0(AUX)].
Set recording speed
Press [REC SPEED] to set the recording speed.
Set timer program on the Inte-
grated HDTV
•
For timer programming method, refer to the
manual of the Integrated HDTV.
Engage recording standby mode
Press [POWER] to turn off the VCR.
- a
•
The Integrated HDTV will activate the VCR to
automatically start recording through the Video
Remote Controller at the programmed time.
or
49
EN