Devolo MAGIC 2 LAN Triple Manual page 32

ted by corresponding flashing behaviour regard-
less of this setting.
Powersaving
If Powersave mode has been enabled, the
devolo Magic 2 LAN triple switches to Powersave
mode automatically whenever reduced data trans-
mission over ethernet is detected.
The latency (time for transmitting a data
packet) may be negatively affected.
Powersave mode is
devolo Magic 2 LAN triple factory default settings.
Standby
If
devolo Magic 2 LAN triple automatically switches
to Standby mode if no ethernet connection has
been enabled, i.e. if no network device (e.g. com-
puter) is switched on and connected to the net-
work interface and if Wi-Fi is disabled.
In this mode, the devolo Magic 2 LAN triple is not
accessible over the Powerline network. As soon as
the network device (e.g. computer) connected to
the network interface is switched on again, your
adapter can also be accessed over the electrical
wiring again.
Standby
devolo Magic 2 LAN triple factory default conditi-
on.
Firmware update
The firmware of the devolo Magic 2 LAN triple
includes the software for operating the device. If
necessary, devolo offers new versions on the
disabled in the
Standby mode is
mode is enabled
The currently installed firmware of the
devolo Magic adapter is displayed on the
overview page (see 4.2.1 Overview).
devolo Magic 2 LAN triple
Configuration 32
enabled, the
in the