Axis P3265-V User Manual page 10

AXIS P3265-V Dome Camera
Configure your device
3. Select Video format H.264.
4. Go to Video > Stream > General and increase Compression.
5. Go to Video > Stream > H.264 and H.265 encoding and do one or more of the following:
- Select the Zipstream level that you want to use.
Note
The Zipstream settings are used for both H.264 and H.265.
- Turn on Dynamic FPS.
- Turn on Dynamic GOP and set a high Upper limit GOP length value.
Note
Most web browsers don't support H.265 decoding and because of this the camera doesn't support it in its web interface.
Instead you can use a video management system or application that supports H.265 decoding.
Set up network storage
To store recordings on the network, you need to set up your network storage.
1. Go to System > Storage.
2. Click
3. Type the IP address of the host server.
4. Type the name of the shared location on the host server under Network share.
5. Type the username and password.
6. Select the SMB version or leave it on Auto.
7. Select Add share even if connection fails if you experience temporary connection issues, or if the share is not yet
configured.
8. Click Add.
Record and watch video
Record video directly from the camera
1. Go to Video > Image.
2. To start a recording, click
If you haven't set up any storage, click Set up. For instructions on how to set up network storage, see Set up network
storage on page 10
3. To stop recording, click
Watch video
1. Go to Recordings.
2. Click
Add network storage under Network storage.
.
again.
for your recording in the list.
10