Frigidaire FHPC102AC1 Use & Care Manual page 18

18
OPERATING INSTRUCTIONS
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
How to Use the Remote Control
Turning the unit on
Plug in the unit, then press the "on·o " button
When turned on, the unit will operate
according to the last settings before shutdown.
To switch the unit o , press "on·o " button
again, then remove the plug.
Do NOT switch the unit o by removing the
plug. Always switch the unit o by pressing
the "on·o " button and wait for few minutes
before removing the plug.
Cool mode
Press the "mode" button until the left side of
LCD screen displays "cool".
Press the "speed" button to choose the fan
speed "auto", "high", "mid", and "low".
Press the " " and "
temperature you want.
Dry mode
Press the "mode" button until the left side of
LCD screen displays "dry".
In this mode, the "
disabled and the screen will remain blank.
The unit will continuously drain moisture
from the room.
" button to choose the
" or " " button is
Note:
In this mode, the fan speed will be set as
"low" automatically, which cannot be
changed.
In this mode, condensate drainage is
required, refer to the "Drainage Instructions"
on Page 21 for more instructions to drain the
excess condensate.
Fan mode
Press the "mode" button until the left side of
LCD screen displays "fan".
In this mode, you can select fan speed
"high", "mid", "low" by pressing the Fan
speed button and referring to the diagram.
Note: In this mode, the air exhaust hose
does not need to be connected.
Auto mode
Press the "mode" button until the left side of
LCD screen displays "auto".
Press the " " and "
temperature you want.
In this mode, the unit will automatically
select cooling, heating(not applicable for
" button to choose the