Sharp SJ-WS320TS Service Manual page 45

3. How to remove the door (R and F doors)
(1) Remove the Door cam cover l. (F door only)
(2) Open the Door and remove the Door cam tl-k.
(3) Close the door. While pressing it in the direction as
shown in the figure, open the opposite side.
[1] While pressing
(4) The upper part of the door is disengaged.Pull the
door upward and remove.
Door cam cover l
Craw
Door cam tl-k
[2] Open
4. How to install the door (R and F doors)
(1) To four corner Door cams, apply silicone oil to the
part shown in the figure below.
Side face
(2) Engage the edge of the door with the left hinge pin
(*).
* Without door cam
(3) Close the door. While pressing it from the right
side, open it at the opposite side.
[2] Open
(4) Install the Door cam tl-k.
(5) Install the Door cam cover l. (For F door only)
45
SJ-WS320T-S
Side face
Upper face
Inner side face
and inner bottom face
Door cam
is not present
[1] While pressing
Caution
Do not omit the step [1]
above.
Otherwise, the door will
fall as you open it,
causing bodily injury.
Door cam tl-k