Sharp SJ-WS320TS Service Manual page 39

4. DEFROST HEATER ASSEMBLY
1. Taking-out Evaporator
1. Take-out Fan louver.
2. Take-out E.V cover ass'y.
Evaporator
Food liner convex part
3. As shown in Figure A-2, pull the upper part of
Evaporator toward you, pull it diagonally so that the
pipe of Evaporator does not contact the convex part
of food liner.
Evaporator
Pipe
4. Pull the Evaporator for remove as shown in Figure
A-3.
NOTE: When pulling Evaporator and bending the
pipes,pay attention so as not to break and deform
the pipes. Still, take care not to hurt yourself by fin of
Evaporator.
Evaporator
Figure A-1
Food liner convex part
Figure A-2
Figure A-3
2. Replacement of Def. heater ass'y.
1.Remove the Ev cover al,the Fl al sheet.
Remove the Screw.
2. Take off the Drain support al from the food liner.
3. Raise the protrusion part of Drain support al.
Then remove Heater cover.
Drain support al
Protrusion part of Drain support al (2 pcs.)
Heater cover
4. Open Def.heater fixed part of Drain support al to
the right and left, then remove Def.heater ass'y.
Drain support al
39
SJ-WS320T-S
Drain support al
Figure A-4
Protrusion part
Heater cover
Def. heater ass'y
Figure A-5
Fixed parts
Def. heater ass'y
Figure A-6