JVC GR-SXM937UM Instruction Manual page 58

58
EN
When the System Select Switch is set to "VIDEO":
SYMPTOM
RECORDING
Recording cannot be performed.
Recording does not start.
Animation or Time-Lapse is not
available.
PLAYBACK
The tape is running, but there is no
playback picture.
Playback cannot be performed.
Playback picture is blurred or
interrupted.
The counter indication is blurred during
Still playback.
TAPE TRANSPORT
The tape stops during fast-forward or
rewind.
Rewinding or fast-forwarding cannot be
performed.
OTHER
The picture is blurred in the Quick
Review or Retake mode.
The date and time displays
disappear.
The wrong date and time are displayed/
recorded.
The tape will not eject.
TROUBLESHOOTING
POSSIBLE CAUSE(S)
Make sure the Erase Protection tab is in the position that allows
recording. If not, slide the tab. Some cassettes have removable
tabs. If the tab has been removed, cover the hole with adhesive
tape ( pg. 12).
If the System Select Switch is set to "D.S.C.", it is not possible
to record onto the tape. Change the Switch position to
"VIDEO" ( pg. 18).
The camcorder Power Switch has not been set to
"CAMERA" ("AUTO" or "PRO.") (
Before recording in the Animation mode at the very beginning
of a tape, set the camcorder to the Recording mode for about 5
seconds, so that the tape runs smoothly. Using the Fade-in
function at this point is a good way to begin an animated
program ( pg. 35, 56).
The TV has not been set to its VIDEO mode or channel.
If A/V connection is used, the TV's VIDEO/TV Switch has not
been set to VIDEO.
If the System Select Switch is set to "D.S.C.", it is not possible
to play back a tape. Change the Switch position to "VIDEO"
( pg. 39).
The video heads are dirty or worn out. Consult your nearest
JVC dealer for head cleaning or replacement.
This is normal.
The Counter Memory Function has been activated (
The tape is already fully wound on one reel or the other.
This is normal while recording in the EP mode. Some noise
may be present while recording in the SP mode (
If you remove the power source from the camcorder while the
power is on, all settings and selections are erased. Make sure to
turn the camcorder's power off before disconnecting the power
source.
If you have not performed Date/Time Setting (
date and time are not displayed/recorded correctly. Be sure that
Date/Time setting is carried out.
The battery pack is running low.
If the LCD monitor is not open over 60 degrees, EJECT switch
does not function.
(cont.)
pg. 18).
pg. 40).
pg. 14).
pg. 13), the