Basic Playback - JVC GR-SXM937UM Instruction Manual

44
EN
System
Select Switch
Next/Previous
Page (2/PAGE –
or 3/PAGE +)
Buttons
To move
the page next
Power Switch
Display
To move
the page back
D.S.C. PLAYBACK
Still images shot using this camcoder are automatically
numbered, then stored in numerical order in the built-in
memory. You can view the still images stored in memory,
one at a time, much like flipping through a photo album.
1
Set the System Select Switch to "D.S.C.", and set the
Power Switch to "PLAY". The power lamp lights and
a still image stored in memory is displayed.
•When no still image is stored in memory, the screen
becomes blue.
2
Press 3/PAGE+ or 2/PAGE– to select the still
image you want to view.
•Each time 2/PAGE– is pressed, the page goes
back, while each time 3/PAGE+ is pressed, the
page goes next.
•Even if you shoot a new picture after playing back a
still image with a low number, this will not
overwrite the existing picture because new pictures
are automatically stored after the still image most
recently stored in memory.
•If there are no stored images, "NO IMAGES
STORED" is displayed.
NOTES:
When the Power Switch is set to "PLAY" and the LCD
monitor is opened at an angle of 60 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save power.
The playback picture can be viewed in the viewfinder
(with the LCD monitor shut), on the LCD moitor or on a
connected TV ( pg. 42).
When viewing a playback picture on a connected TV, it
may jitter slightly.
You can also view the playback picture on the LCD
monitor with it flipped over and retracted.
To brighten the LCD monitor, rotate the Select Wheel
(BRIGHT) towards " + ". To darken the LCD monitor,
rotate it towards " – ".

Basic Playback