Datalogic LT-700 Quick Start Manual

LT-700 LINEAR ARRAY
LIGHTING SYSTEM
DESCRIPTION
The LT-700 Linear Array Lighting System provides a high intensity light
source designed for the following applications:

with uneven, noisy and scratched surfaces

where dot peening or laser etching codes are directly marked onto
metal surfaces or PCBs and need to be highlighted. Here the use
of more than one LT-700 at different positions can remove any
shadowing effect.

in the presence of highly reflective surfaces (metal, glass, etc.)
causing direct reflections. Low light path to surface angles strongly
reduce direct reflections.
MECHANICAL DIMENSIONS
33 68
[1.28] [2.68]
31.0 54.0
[1.22] [2.13]
M 3 n°2
DEPTH 5
15.5 8.0
[0.61] [0.31]
54.0
[2.13]
M 3 n°2
DEPTH 5
Matrix 210™ Straight Model
The Matrix 410™ reader does not mount directly to the
BK-21-000 bracket.
NOTE
WIRING
M 3 n°2
DEPTH 5
8.0 15.5
Wire Color CBX/Matrix Signal
[0.31] [0.61]
Red Vdc
Black GND
White Earth
mm
Green O1- or O2-
[inch]
Yellow O1+ or O2+
Matrix 210™ 90° Model
Matrix 410™
Meaning
10 to 30 Vdc
Ground
Shield/Earth Ground
Control Signal -
Control Signal +
MOUNTING LT-700
The following parts are required for mounting:
 LT-700 Linear Array Lighting System
 Accessory BK-21-000 LT-700 Fixing Bracket
A
C
D
Example BK-21-000 Assembly
A
1. Mount the rotating bracket (2 pieces) onto the Reader Mounting
B B'
Bracket (for straight models) or
the M3 screws. Do not completely tighten the screws.
C
2. Mount the LT-700 sliding bracket
using 2 of the M3 screws and 2 washers. Do not completely
tighten the screws.
D
3. Mount the LT-700 onto the LT-700 sliding bracket
the M3 screws and 2 washers. Do not completely tighten the
screws.
4. Mount the Matrix 210™ reader to the Reader Mounting Bracket
B'
(for straight models) or (for 90° models).
If LT-700 is used with Matrix 410™, the reader must be mounted
separately.
5. Mount the entire assembly to the reading station frame (i.e. Bosch
profile).
6. Wire the LT-700 to the CBX according to the Wiring table.
7. Follow the Positioning instructions in the following paragraph.
B
B'
(for 90° models) using 2 of
A
onto the rotating bracket
C
using 2 of
B