Jacuzzi J - 355 Owner's Manual page 17

north american J-335, J-345, J-355, J-365 and J-375 Models (60 hz)
Circuit Breaker (2-Pole):
Number of Wires:
Frequency:
Current Draw:
In 40A configuration, the heater will not operate while either jets
*
pump is running in high speed. Note: pump 2 runs only in high
speed.
** In 50A configuration, the heater will not operate while both jets
pumps are running in high speed. This is the factory setting.
Note: pump 2 runs only in high speed.
*** In 60A configuration the heater will operate while both jets pumps
are running in high speed.
north american J-315 and J-325 Convertible Models (60 hz)
Circuit Breaker:
Number of Wires:
Frequency:
Current Draw:
* all Canadian spas must be hard wired per Csa Canadian standards
(page 8).
† In 15A/30A configuration, the heater will not operate while the jets
pump is running in high speed. The factory setting is 120V/15A.
‡ In 40A configuration, remove jumper JP1-2 on the board, to allow the
heater to operate while the jets pump is running in high speed.
‡ Caution (For 4-wire 240 vaC Heater operation): Move the red
wire on the main terminal strip (TB1) from position #1 to position #3.
Make certain wires are connected exactly as shown in Figure D (Page
17) before applying power. Failure to do so will result in damage to the
circuit board and/or related components and void the manufactures
warranty.
240V/40A*
40A
3
60 Hz
26A
120V/15A†
15A, 1-Pole
3 (15A GFCI 4 (Hard Wire
Cord US
Only*)
60 Hz
12A
J-300 series
J-300 Series
240V/50A** 240V/60A***
50A
3
60 Hz
36A
240V/30A†
40A , 2-Pole
30A, 2-Pole
4 (Hard Wire
Only)
60 Hz
21A
60A
3
60 Hz
45A
240V/40A ‡
Only)
60 Hz
30A
13 13