Advertisement
Available languages
Available languages
After use / Drain the water
• Turn off the equipment by unplugging it from the
mains supply.
• Remove the trays.
• Allow the water to cool down.
• Poor the water out of the container
• Only for Bain marie with water drain: Place a
IMPORTANT: Always ensure that the water level isn't below "MIN"! Check this regularly, also during use.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use
abrasive materials.
Technical Specification
Item no
Operating voltage &
frequency
Rated input power
Capacity
Temperature range
Dimension
REMARKS: Technical specification is subjected to change without prior notification.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are
still unable to solve the problem, please contact the supplier/service provider.
Fault
Appliance does not do
anything
Appliance does not do
anything
Appliance does not
reach the set temper-
ature..
238905
230V~ 50Hz
1200W
19L
to 85°C
340x540x(H)255mm
Symptom
green switch light does not
light and the green control
light does not light
green control light does
not light
green control light does
not go out
bucket under the drain pipe.
• Open the drain. The water will drain from the
container.
• When the water has drained from the container,
close the drain.
• Clean the ventilation slots (if applicable) with the
vacuum cleaner.
• If used intensively, regularly remove lime scale
from the bottom of the water tank. Use for this
purpose vinegar or a special descaling agent.
• Avoid as much as possible water contacting the
electrical components.
• Only for Bain marie with water drain: if the wa-
ter being drained is dirty, leave the tap open and
rinse the appliance with clean water.
238912
Possible cause
No power at the power point
Overload circuit breaker
tripped
Thermostat defective
Element defective
Possible solution
Check the electrical
installation
Reset the overload
circuit breaker ( 1 )
Replace the thermostat
Replace the element
5
EN
Advertisement
