Energizer Homepower HP-6M Series Owner's Manual page 4

Do not attempt to open, disassemble, repair or tamper with the Energizer Homepower HP-6 Series
units, as doing so may result in damage to equipment and/or cause injury or death. Contact the
Energizer Homepower authorised reseller for any repairs.
Always de-energise the AC branch circuit during an emergency and/or before servicing the
Energizer Homepower HP-6 Series system. Never disconnect the DC connectors under load.
Energizer Homepower HP-6 Series units can present a risk of high short-circuit current.
Observe the following precautions when operating the system:
• Remove watches, rings, or other metal objects.
• Use tools with insulated handles.
• Wear rubber gloves and boots.
When placing Energizer Homepower HP-6 Series units in storage, ensure that the battery
isolator is switched off.
Warnings
During usage, always keep the Energizer Homepower HP-6 Series units in an upright position. Do
not impact, pull, drag, step, or apply strong force on the Energizer Homepower HP-6 Series units.
To help prevent damage, leave the Energizer Homepower HP-6 Series units in their original shipping
packaging, until they are ready to be installed.
Ensure the Energizer Homepower HP-6 Series system is installed only on a suitable wall, using the
wall-mount bracket included.
Do not use solvents and/or cleaning fluids to clean the Energizer Homepower HP-6 Series units or
expose them to harsh chemicals or vapours.
Do not use any third-party accessories, fluids, or paint to alter the internal or external components
including the exterior casing.
V23-00211
6
Energizer Homepower HP-
6 © Energizer 2021
Series Energizer Homepower HP-
Do not sit on, step on, place objects on or insert objects into Energizer Homepower HP-6 Series
units. Please refrain from placing liquids or containers (with liquids) on top of the Energizer
Homepower HP-6 Series units.
Damage to the Energizer Homepower HP-6 Series units can occur from over-discharge. While in
storage, it is expected to discharge gradually. Ensure that the Energizer Homepower HP-6 Series
units are installed by the "Must Energize by Date" located on the packaging.
If an Energizer Homepower HP-6 Series unit needs to be replaced or removed, it must be turned off
as per the recommended shutdown procedure prior to removal.
Ensure the absence of any water sources above or near Energizer Homepower HP-6 Series units,
including sprinklers, water jets, garden hoses or faucets.
If the Energizer Homepower HP-6 Series units are being installed in a garage or near moving
vehicles, it is recommended to install the unit clear of the driving path and provide necessary
protection in the form of bollards.
Definitions
SoC
- State of Charge.
CT's
- Current Transformer Sensors.
BMS
- Battery Management System.
Generation
- Refers to the electrical energy produced by your solar system.
Consumption - Refers to the electrical energy used within your household.
V23-00211
6
Series
7 © Energizer 2021