Teka DHT 97670 User Manual page 13

- Make sure all of the appliance components are not damaged.
In such a case, do not carry out installation and contact a
qualified technical assistance center.
- Qualified installers shall make any necessary carpentry and
installation works in full compliance with directives in force.
- Do not connect the appliance to the electrical network during
installation.
- Disconnect the appliance from power supply before carrying
out any cleaning or maintenance operation.
- Need to allow the disconnection of the appliance from the
mains supply after the installation, through an accessible plug
or main switch.
- Steam cleaner should not be used.
- Do not use harsh abrasives or sharp metal scrapers to clean
glass since they can scratch the surface, which can cause the
glass to break.
- CAUTION: Ensure that the appliance is disconnected (OFF)
before replacing the lamp to avoid the possibility of electric
shock.
- Do not remove the protective plastic from the hood until it is
completely installed, if this plastic is not present in areas that
could have a risk of damage during installation. This will avoid
damage to the outside of the appliance, something that will not
be covered by the guarantee.
13