Problem Solving - Chacon 34035 User Manual

3. Wall installation of the control unit
1. Once you have installed the batteries, choose a location for your motion
detector.
2. Fix the bracket to the wall using the supplied dowels and screws.
3. Fit the sensor onto the bracket and then choose the best angle for
the sensor to have the best possible field of view.
100° 80° 60° 20°
100°
2m 4m 6m 8 m
Recommended installation height: Maximum 160cm and minimum 30cm.
NOTE: Adjust the installation angle so that it faces downwards.
4. Mode on the remote control
The remote control has an «On» button to activate the alarm and an «Off» button to deactivate it.
On the side of the remote control there are two inscriptions «HOME» and «AWAY».
a) Home mode: When you select «HOME» mode with the switch, it means that you are at home and don't want to be
disturbed. Slide the switch on the remote control marked «HOME» and press the «On» button.
b) AWAY mode: When you select the «AWAY» mode with the switch, it means that you are leaving your home and want
to turn off your alarm. Slide the switch on the remote control marked «AWAY» and press the «On» button
NOTE: In «home» mode, all motion detectors are disabled.
4. Reset pairing
In order to reset your entire alarm, remove the batteries from your device. Then press and hold the learning button
(see diagram point 1.). When you reinsert the batteries, you will hear two «beeps» indicating that the reset was
successful.

5. Problem solving

1. False alarms from the main unit
a) Check that there are no animals near the motion detector.
b) In hot weather, moving shadows may also activate the alarm. Also ensure that the detector is not installed near a
radiator or heat source.
EN