Table of Contents
Advertisement
11.2 Warning Messages (WXXXX)
Code
W0001
Save system data?
Some parameters on the screen were changed. A click on "OK" or a screen switch was
attempted without saving data.
W0002
The status of the port is In-Service (INS). Would you like to continue?
When the status of a port is In-Service (INS), and you change some parameters (screens
of "1 Configuration"), the port is reset. A call in progress will be dropped.
W0003
Save system data before Copy?
Modified parameters without saving are not effective for Copy feature.
W0005
Save data file?
Tried to close, exit or open another file without saving data in the Batch mode (although
parameters were changed).
W0006
Mismatch between PC software version and PBX software version. Proceed to
load matching PC software?
PC software (Maintenance Console software) is not compatible with the current KX-
TD500 software. Load the appropriate PC software into your PC. (Then connect your
PC to the KX-TD500 again.)
W1001
Change the card (XXX:YYY) status?
Please confirm whether or not to execute OUS (Out-of-Service) / INS (In-Service)
command to the card "XXX:YYY" (XXX: Slot No., YYY: Card Type).
The OUS (Out-of-Service) / INS (In-Service) command to the card is effective to the
whole ports of the card.
W1002
Change the status of port (XXXXX)?
Please confirm whether or not to execute OUS(Out-of-Service) / INS(In-Service)
command to the port "XXXXX" (XXXXX: port physical number).
W1003
Make sure the card is "OUS," before changing the "Card Properties.
" If the card is already "OUS" to change the properties, or just to view "Card
Properties," click "OK." To change the card to "OUS," click "Cancel."
W1004
DTMF Caller ID code must not exceed 16 characters. Truncate it?
Truncate means that the leading 16 characters are saved and the rest are deleted.
W3001
PBX code must not exceed 4 digits. Truncate it?
Truncate means that the leading 4 digits are saved and the rest are deleted.
W3002
Please verify that previously erased FDN is not programmed in other screens.
The erased FDN may be used in other screens.
W4001
Trunk name must not exceed 10 characters. Truncate it?
Truncate means that the leading 10 characters are saved and the rest are deleted.
Programming Guide
Message
Description
Programming Error Messages
349
Advertisement
Table of Contents
