Brother MFC-J5340DW Quick Setup Manual page 2

8
Machine settings
Follow the LCD instructions to configure
the machine settings.
• Configure the tray settings and check
the paper orientation information (not
available on all models).
• Check the software installation
information.
Select your language
10
(if needed)
1. Press [Settings] > [All
Settings] > [Initial Setup] >
[Local Language].
2. Press your language.
3. Press .
Connect your computer or mobile device to your machine
13
Follow these steps to complete the setup using one of the connection types available on your machine.
Visit setup.brother.com to download and install
Brother software.
setup.brother.com
NOTE
For Windows only, CD installation is also available (for
some countries).
Can't Connect? Check the following:
Wireless network
Wired network
USB connection
Manual wireless setup
14
If the wireless setup is not successful, try to set up the connection manually.
Find your SSID (Network Name) and Network Key
(Password) on your wireless access point/router
and write them in the table provided below.
SSID (Network Name)
Network Key (Password)
SSID: XXXXXXX
Network Key: XXXX
If you cannot find this information, ask your network
administrator or wireless access point/router
manufacturer.
For detailed machine information and product specifications, see the Online User's Guide at support.brother.com/manuals.
Connect the telephone line cord
9
If you are not using your machine as a fax, go to
Online User's Guide.
Lift the scanner cover.
Select the correct
11
Receive Mode
If you are not using your machine as a
fax, go to .
13
1. Press [Settings] > [All Settings]
> [Fax] > [Setup Receive] > [Receive
Mode].
2. Press your preferred Receive Mode.
3. Press .
Follow the on-screen instructions and prompts.
NOTE
For Wired Network Connection and USB Connection,
locate the correct port (based on the cable you are using)
inside the machine as shown.
Restart your wireless access point/
router (if possible).
Disconnect the cable.
Go to your machine,
and press >
[Find Wi-Fi Network] >
[Yes].
. For more information on using the fax feature, see the
10
Connect the telephone
line cord. Use the jack
marked LINE and guide
the cord out the back of
the machine.
Set your Station ID
12
If you are not using your machine as a fax, go to
Store your name and fax number so the machine prints it on
all outgoing fax pages.
1. Press [Settings] > [All Settings] > [Initial
Setup] > [Station ID] > [Fax].
2. Enter your fax number (up to 20 digits) on the touchscreen
and then press [OK].
3. Press [Name].
4. Enter your name (up to 20 characters) using the
touchscreen, and then press [OK].
5. Press .
You can now print and scan using your machine.
To check for the latest firmware, visit
support.brother.com/up7.
Important Notice for Network Security:
The default password to manage this machine's
settings is located on the back of the machine
and marked "Pwd". We recommend immediately
changing the default password to protect your
machine from unauthorized access.
Restart your machine and
computer, and then go to 13 .
Select the SSID (Network
Name) for your access point/
router and enter the Network Key
(Password).
When the wireless setup is
successful, the LCD displays
[Connected].
If setup is not successful, restart
your Brother machine and your
wireless access point/router, and
14
repeat .
Close the scanner cover.
Setup Finished
14
If still not successful, go to .
If still not successful, visit support.brother.com
for FAQs and Troubleshooting.
Go to 13 to install software.
© 2021 Brother Industries, Ltd. All rights reserved.
13 .