Driving Procedure - Axis E1 Owner's Manual

Driving Procedure

1. Disconnect the charging cable (if connected).
2. Wear a helmet, eye protection, gloves, long-sleeve
shirt, long pants and over-the-ankle boots.
3. Sit in the driver's seat and fasten the seat belt.
4. Apply the brakes.
5. Turn the key to the ON position. Wait about a
second for the contactor to close before continuing.
6. Move the direction selector to forward or reverse.
7. Move the drive mode switch to the desired setting.
8. Release the park brake.
9. Check your surroundings and determine your path
of travel.
10. Keeping both hands on the steering wheel, release the brake pedal and gradually push the
accelerator toward the floor to begin driving.
11. Drive slowly. Practice maneuvering and using the accelerator and brakes on level
surfaces.
12. Do not carry a passenger until you have at least two hours of driving experience with this vehicle.
Never carry more than one passenger in this vehicle. Never allow a passenger to ride in the
cargo box.
13. To stop the vehicle, release the accelerator pedal completely and brake to a complete stop.
14. Set the park brake.
15. Turn the key off.
WARNING! A rolling vehicle can cause serious injury. Always set the park brake when leaving
the vehicle unattended.
OPERATION
48