Seat Belts - Axis E1 Owner's Manual

Seat Belts

This HSUN vehicle is equipped with three- point lap and
diagonal seat belts for the operator and passenger.
Always make sure the seat belts are secured for all riders
before operating.
The center of the seat is NOT equipped with a seat belt.
Never allow a passenger to ride between the operator
and passenger seats.
WARNING!
Falling from a moving vehicle could result i n
serious injury or death. Always fasten your seat belt
securely before operating or riding i n the HS5D-EV.
To wear the seat belt properly, follow this procedure:
1. For 3-point belts, pull the seat belt latch downward
and across your chest toward the buckle at the inner
edge of the seat. The belt should fit snugly across
your hips and diagonally across your chest. Make
sure the belt is not twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self tighten.
4. To release the seat belt, press the square red button i n the buckle's
cent
** THIS VEHICLE WILL NOT OPERATE WITHOUT THE DRIVERS SEAT
BELT LATCHED.
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly into the
buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage, including cuts,
wear, fraying or stiffness. If any damage is found, or if the seat belt does not operate properly,
have the seat belt system checked and/or replaced by an authorized HSUN dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water. Do
not use bleach, dye or household detergents.
FEATURES AND CONTROLS
46
/ 4
Latch Plate
Buckle