Before Using The Refrigerator; Electrical Connection - Defy D190 Instruction Manual

4. Place your refrigerator on an even floor surface to
prevent jolts.
5. Do not keep your refrigerator in ambient
temperatures under 10°C.
Please make sure that the interior of your refrigerator
is cleaned thoroughly.
Your refrigerator should be installed at
least 30 cm away from heat sources
such as hobs, ovens, central heaters
and stoves and at least 5 cm away from
electrical ovens and should not be
located under direct sunlight.
If two refrigerators are to be installed
side by side, there should be at least 8
cm distance between them.
Before using the refrigerator check that:
1. The feet have been adjusted for perfect levelling.
2. The interior of the refrigerator is clean and dry.
3. Check the required distance between your
refrigerator and the wall in order to allow for free
air circulation.
4. The DC power supply has been correctly
connected. When the door is open the interior light
will come on.
5. You may hear a noise as the compressor starts
up. The liquid and gases sealed within the
refrigeration system may also give rise to noise,
even if the compressor is not running, this is quite
normal.
6. Do not load the refrigerator immediately after it is
switched on. Wait until the correct storage
temperature has been reached.

Electrical connection

This appliance operates on 12 or 24
Volts DC (Direct Current) only! Under
no circumstances must this
appliance be directly connected to an
AC (Alternating Current) power
source.
Polarity is important in wiring this DC appliance. Be
sure that the positive terminal of the battery or charge
controller coincides with the positive wire to the
compressor, and the negative terminal of the battery
or charge controller coincides with the negative wire
to the compressor.
The leads should be connected using cable shoes
and screwed connections. Joined leads should be
avoided.
THE APPLIANCE MUST ONLY BE
CONNECTED TO A 12V OR 24 VDC
POWER SOURCE, SUCH AS A
BATTERY OR CHARGE
CONTROLLER. THE UNIT WILL
AUTOMATICALLY OPERATE ON
EITHER 12 OR 24 VDC. THE USER
DOES NOT NEED TO MAKE ANY
ADJUSTMENT.
NOTE: COMPRESSOR MAY NOT
START WITHOUT A BATTERY IN THE
CIRCUIT. BATTERY MUST BE AT
LEAST 100 AH CAPACITY.
+ to + and
Positive to Positive and Negative to
Negative
IMPORTANT: Before connecting the
appliance, please see the installation
diagram on page 18.
When operating your refrigerator for the first time,
please observe the following instructions during
the initial six hours:
• The door should not be opened frequently.
• The refrigerator must be operated empty without
any food in it.
• Do not unplug your refrigerator.
• Original packaging and foam materials should be
kept for any future transportation or moving.
Please remember that the manufacturer shall not
be held liable if the information given in the
instruction manual is not followed.
Page 8
to