Table of Contents
Advertisement
Energy saving tips
• Ensure your refrigerator is installed in a well
ventilated area. If the ambient temperature is low
(but in no case lower than 5 degrees C), then the
energy saving will be more. Do not install your
refrigerator under direct sunlight or near heat
emitting appliances such as ovens, dishwashers or
radiators. Keep food in closed containers.
• Ensure the time between buying chilled/frozen
food and placing it in the refrigerator is kept at a
minimum, particularly in summer. Use a cooler bag
or a special carrier bag to carry frozen food. Do
not put hot food or drinks in the refrigerator.
• Do not leave the door(s) of the refrigerator open
for long and ensure they are closed properly after
each opening.
Placing foods
Freezer
Various frozen food such as meat,
compartment
fish, ice cream, and vegetables.
shelves.
Egg holder.
Eggs.
Fridge
Food in pans, covered plates and
compartment
closed containers.
shelves.
Fridge
Small and packaged food or drinks
compartment
(such as milk and fruit juice).
door shelves.
Delicatessen products (cheese
and butter).
Crisper.
Vegetables and fruits.
Values stated in the documentation are
obtained in laboratory conditions in
accordance with the relevant standards.
Depending on operational and
environmental conditions of the
refrigerator, these values may vary.
If your refrigerator is not going to be
used for a long period of time, unplug the
power cable, remove all food, clean it
and leave the door ajar.
• Defrost your refrigerator regularly.
• Defrost frozen food in the fridge compartment, so
that frozen food acts as an ice pack to assist
cooling in the fridge. This will provide energy
saving and preserve the food quality.
• Do not put hot food or drinks in your refrigerator.
• Do not overload your refrigerator. This restricts
effective air circulation in the refrigerator.
• Pay attention to keep your food in closed
containers.
3
Placing and Installation
Transportation instructions
1.The refrigerator must be transported only in an
upright position. The packing must be intact during
transportation.
2. When positioning your refrigerator, take care not to
damage flooring, pipes, wall coverings etc. Do not
move the refrigerator by pulling the door or handle.
When re-transporting your refrigerator
• Your refrigerator must be emptied and cleaned
prior to any transportation.
• The shelves, accessories, crisper etc.
In your refrigerator must be fastened securely with
adhesive tape to protect against any jolts.
• Packaging must be tied with thick tape and strong
rope and the transportation guidelines printed on
the package must be followed.
1. Install your refrigerator in a place that allows for
ease of use.
2. Keep your refrigerator away from heat sources
such as stoves, geysers
sunlight.
3. There must be appropriate air ventilation around
your refrigerator in order to achieve efficient
operation. The refrigerator is to have at least a 50
mm space from the ceiling and at least a 50 mm
space from the wall. Fit the Two plastic wall
spacers supplied with the appliance rotating 1/4
turn to the condenser at the back of the appliance
(See Diagram).
If the floor is covered with a carpet, your
refrigerator must be elevated 25 mm from the floor.
Page 7
humid places and direct
Hide quick links:
Advertisement
Table of Contents
