Table of Contents
Advertisement
The status displayed in *2 is as shown below.
Display
Loading F/W from Update Disc or
EXECUTING
writing to Flash memory
OK
Update successful
ERROR
Error during Flash memory writing
FILE ERROR
Check SAM error in F/W file
READ ERROR Error during F/W file reading
Fig. e: VFD Display during update
Re: the VFD display shown in Fig. e.
When the TV screen displays "Firmware
Updating... XX% Complete," the VFD will indicate
"XX"%.
6. When completing update, the tray will open
automatically.
The TV screen will display Fig. f.
*FIRMWARE version will differ depending on the
model. Fig. f is an example.
DISC UPDATE
TARGET: B/E
STATUS: OK
DISC UPDATING 100% Complete
PLEASE PUSH POWER BUTTON
Fig. f: TV Display when completing update
If the update is completed correctly, the VFD will
indicate Fig. g.
Fig. g: VFD Display when completing update
Fig. h VFD Display when completing update with error
In this case, all button operations will be invalid
except [POWER] button.
7. Press [POWER] button to turn the power off and
press [POWER] button again to turn the power on
and finish updating.
Status
1-10-2
3. How to Verify the Firmware
Version
1. Turn the power on and remove the disc in the tray.
2. To switch the DVD/VCR with HDD recorder into
the HDD mode, press [HDD] on the remote control
unit.
3. Press [VARIABLE SKIP] and [1], [2], [3] buttons on
the remote control unit in that order within 3
seconds. The Firmware version appears on the TV
screen.
4. Press [POWER] button to reset the unit.
E4340FW
Advertisement
Table of Contents
