Amplicomms BigTel 50 Alarm Plus User Manual page 47

Automatic emergency call
The automatic emergency call can be initiated by pressing and hold the
buttons M1, M2 or M3 on the telephone or the button on the emergency
call unit.
If no phone number has been assigned to M1, M2 or M3 no phone num-
ber is dialled but a loud warning signal is issued from the telephone.
Note: Pay attention that the emergency call unit is within range of
the telephone.
The batteries in the emergency call unit should always be full.
Automatic emergency calls via the telephone
• Press and hold down , or for approx. 5 seconds to
start the automatic emergency call function.
• Press or again , or for approx. 5 seconds to end
the automatic emergency call function.
Automatic emergency calls via the emergency call unit
1. Press and hold the button (1) on the emergency call unit for 5 seconds
to start the automatic emergency call function.
2. Press and hold the transmitter button again for 5 seconds to end the
automatic emergency call.
1
47