Installation Of The B-Dj Software; Control Panel Software - Behringer B-CONTROL DEEJAY BCD2000 User Manual

B-CONTROL DEEJAY BCD2000
+
®

2.2 Installation of the B-DJ software

In order to use the B-DJ software without problems, you must
have DirectX , rev. 8.1 or higher. Please check what version of
®
DirectX is installed on your system before you start to install the
®
software.
1. Start > Browse >
2. Select the following option on the left-hand side (below
3. Enter (= DirectX Diagnosis) in the upper text box,
®
and click on
4. Double-click on the file
5. In the DirectX diagnostic program now appearing, the current
DirectX revision stored on your computer is shown at the
®
bottom of the main
1. Open Windows Explorer (My Computer > right mouse
®
button > Explorer)
2. In Windows ® Explorer, select the drive containing the
BCD2000 driver/software CD-ROM (e. g. double click on
DVD drive (D:))
3. Select the folder
4. Double-click on the setup file (.exe) to start installation
5. Follow the on-screen installation instructions.
After installation, the B-DJ software will be ready to operate.
Open the B-DJ program by double-clicking on the B-DJ icon on
the desktop or use Start > Programs > XYLIO B-DJ > B-DJ 1.0.
+
6
for each single
):
found in the folder
page.
2. INSTALLATION

2.3 Control panel software

The BCD2000 control panel allows you to control some general
settings of the BCD2000. The control panel will be available in
the system as soon as the driver has been installed and the
BCD2000 has been connected and switched on. To start the
control panel software, click on the BCD2000 control panel symbol
in the task bar at the bottom right of your screen. If the B-DJ
software has already been started, you can also access the control
panel from the “Configuration” menu.
The following basic settings can be selected in the control panel:
If is selected, you can only adjust the input source for IN A
(Mic or Phono A) and the driver latency on the ASIO page (see
below). The outputs are assigned as follows:
CH 1-2: channels 1-2 are always routed to the MASTER OUT,
CH 3-4: channels 3-4 are always routed to the PHONES OUT.
Additionally, the BCD2000’s MIDI characteristics differ from those
in mode (see below). In ADVANCED mode, all
selection options are available in the ASIO window.
Fig. 2.1: The ASIO window in the BCD2000 control panel
This is where all ASIO driver parameters can be adjusted. Most
professional music programs use ASIO, as does our B-DJ
software.
You can only select one software button per field.
In the field , you can select the input source to be
routed to the computer on channels 1-2 (Record).
In the section, you can select the playback
channels CH 1-2 or CH 3-4 for the main
In the field, you can select the playback channels
CH 1-2 or CH 3-4 for the headphones connector
Use to adjust the latency in order to optimize
your computer’s performance. If you set the control to
will optimize the response of your BCD2000, but also increase
the processor workload. In extreme cases, this can lead to clicking
and drop-outs in the audio signal. The
good compromise between processor workload and the response
time of the BCD2000. A
performance even on slow computers.
+
outputs (Playback).
(Playback).
this
position gives you a
latency ensures trouble-free