Service Mode Table; Dvd/Cd Self-Diagnosis Error Code Description; Mode Table - Panasonic SA-VK82DGCP Service Manual

If several errors are detected, press the
15.3.2. Re-Display
· Press the power button to turn off the power, and then turn on the power.
· The details of self diagnosis are stored in the unit memory.
To retrieve them, follow the procedure described the above, "Activating Self-Diagnosis Function and Displaying Method".

15.4. Service Mode Table 1

Following modes are available with combinations of the pressed buttons on the player and on the remote controller unit.
Player Remote Controller Unit
button
FUNCTIONS

15.5. DVD/CD Self-Diagnosis Error Code Description

Error Code
H15 The disc tray cannot be opened: it closes spontaneously.
H16 The disc tray cannot be closed: it opens spontaneously.
Error Code
U. H. Error
U11 Focus servo failure
H01 Tray loading failure
H02 Spindle servo failure
H03 Traverse motor failure
H04 Tracking servo error
H05 Seek timeout failure
DSC system
F500 DSC failure
F501 DSC not Ready failure
F502 DSC Time out failure
F503 DSC communication failure
F505 DSC Attention Error
F506 Invalid media
Disc Code
F103 IIlegal highlight position
IIC Error
F4FF Forced initialization failure (Time out)
F880 Unsuitable task number
F890 A message is sent during AV task transmission
F891 Unable to transmit a message to AV task
F893 DVD Module problem
F894 EEPROM failure
F895 Firmware compatibility problem
F897 Initialization is not done properly
F8A0 Unsuitable message command

15.6. Mode Table 2

Following modes are available with combinations of the pressed buttons on the player and on the remote controller unit.
button to display each.
0 Error code display (Refer to the Item 15.5. DVD/CD Self-Diagnosis Error Code Description)
5 Tilt adjustment (Jitter)
6 Region number and broadcasting system check
8 Bulit-in program version check (Micro-P)
DVD laser drive current check
3 CD laser drive current check
PAUSE Writing of laser drive current value after replacement of optical pickup
(Do use this function only when optical pickup is replaced.)
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer and its peripherals and printed circuit board.
State, Conditon
Meaning
Usage
Cause, Troubleshooting
Disc tray open/close detection switch (S1001) failure.
(Check and replace)
(Spindle servo, DSC, SP motor, CLV servo failure)
DSC stops due to servo failure.
(Startup, focus failure, etc.)
Communication failure between DSC and system computer
(No communication because DSC does not move)
See F500.
Communication failure (Result failure occurs after communication
command is transmitted.)
See F500.
Disc is placed upside down; TOC is unreadable or invalid disc is
inserted.
Disc standard is possibly illegal when highlight is displayed.
When a message arrives from not existing task
During transmission of a message to AV task
When transmission of a message to AV task starts
Check for firmware version
Check for firm version for Main & DVD Module P.C.B.
Follow proper steps for initialization & reset
When transmission of a message to AV task starts
21
SA-VK82DGCP / SA-VK82DGCS / SA-VK82DGS
Details