Note that the selection in this menu item will only be effective if the device is accessed
through the BIOS.
Î IDE Detect Time Out (Sec)
IDE Detect Time Out (Sec) allows you to select the timeout value for detecting ATA/ATAPI
devices. The default [35] is recommended. The timeout value options are:
0
„
5
„
10
„
15
„
20
„
25
„
30
„
35 (Default)
„
Î ATA (PI) 80Pin Cable Detection [Host & Device]
Î
Host & Device
Î
Host
Î
Device
5.3.2.1 IDE Master and IDE Slave
IDE Master and IDE Slave configuration options for both primary and secondary IDE
devices are shown in the BIOS menu below.
(D
)
Uses the host and device to detect the 80-pin
EFAULT
ATA(PI) cable
Uses the host to detect the 80-pin ATA(PI) cable
Uses the device to detect the 80-pin ATA(PI) cable
3301690 CPU Card
85