Restore Factory Default Settings - Lutron Electronics Sunnata ST-PRO-N Manual

Restore Factory Default Settings

The dimmer can be returned to its original factory settings . This allows the customer a risk-free experience to try
multiple settings .
Default Settings
Feature
High-end trim
Low-end trim
Light level indicator / Locator light
Light bar brightness
Preset light level
1 . Triple tap the button rapidly, holding on the last press .
Off
2 . Continue holding until the light bar and the lighting load begin to raise from low to high in about 3 seconds .
3 . Immediately triple tap the
4 . The light bar and lighting load will begin to raise from low to high 3 times, the middle of the light bar flashes, the lights turn
off and then turn back on to high-end .
1.
TAP 3x
(in <1 sec)
System Features (HRST- and RRST- Models Only)
Note: If setting up as part of a system, phase settings and low-end trim levels made on the dimmer will be over-written by
the system software .
RRST-PRO-N - For use in a RadioRA 3 system, please refer to the Getting Started Guide: www .lutron .com/RA3support
Some dimmer behavior features can only be adjusted through the Lutron Designer software .
1 . Fade ON/OFF rate: The rate at which the load turns ON or OFF from its previous state .
2 . Delayed Long Fade-to-Off (DLFTO) Time: Allows for control over how quickly / slowly the load begins the start of the
dimming sequence . This setting delays the time between when the
lights actually begin the fade-to-off process .
®
Application Note #734
Default
Highest level of trim range
Middle level of trim range
ON /ON
Medium brightness
Tapping the
lights to full (locked preset at high-end)
button again and release .
Off
UNTIL
HOLD
(~3 sec)
button always sets the
On
2.
AND
LOW TO HIGH
button is pressed (normal operation) and when the
Off
14
3.
TAP 3x
(in <1 sec)
www.lutron.com/support