Brake Rod Adjustment; Caster Wheels; Cleaning; Hardware - Husqvarna WG4815E, WG3613E Operator's Manual

Husqvarna walk-behind mower operator's manual
Hide thumbs Also See for WG4815E, WG3613E:
Table of Contents

Advertisement

Brake Rod Adjustment

The brake rod should be in the lower hole on the brake
arm. Make sure the rod is properly installed.
To increase braking, turn the wing nut down on the
rod. Do not turn the wing nut down too far as this will
result in a constant braking action and will excessively
wear the brake lining and cause premature failure.

Caster Wheels

Check every 200 hours. lift front of unit off of ground
so caster wheels can rotate freely. Tighten caster bolt
then loosen ½ turn. Check that wheel rotates freely. If
wheel does not rotate freely, loosen the caster bolt in
¼ turn increments until wheel rotates freely.
Foam filled tires or solid tires will void the warranty.

Cleaning

Under side of rear deck
Remove grass and debris.
Washing
Regular cleaning and washing, especially under the
mower deck, will increase the machine's lifespan.
Make it a habit to clean the machine directly after use,
before the dirt sticks. Do not spray high pressure water
directly on the top of the deck.

Hardware

Check daily. Inspect the entire machine for loose or
missing hardware.
MAINTENANCE
Brake rod position
Caster wheel
Regularly clean deck
8011-774
8011-619-2
8011-639-01
Husqvarna-41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wg3613bfWg3613ec

Table of Contents