Table of Contents
Advertisement
Parking Brake
Visually check that no damage is found on the neutral
bail. Perform a test drive and check that there is
sufficient braking action.
To adjust the handbrake, contact the service workshop
if you are uncertain. Set the neutral bail in the neutral
lock position. Tighten the wing nut. Check if the
machine is braked, if not tighten the wing nut again.
V-belts
Deck belt
Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in
normal operation.
To replace belt, set deck to its lowest position.
Remove the plate and belt shields.
9
Use a ratchet with a
/
16
to relieve the tension on the belt. Slide the belt off the
pulley and fully remove the belt.
Reverse the procedure for installation. See the decal
on the top of deck for belt routing information.
After installation is complete check the belt for twists.
MAINTENANCE
" socket on the spring idler bolt
Neutral bail in the neutral lock position
Slacken the belt tensioner
8011-477
8011-775
Husqvarna-39
Advertisement
Table of Contents
