Trane WCVS 270 Installation Operation & Maintenance page 3

Foreword
These instructions do not attempt to
cover all variations in system, nor to
provide for every possible contingency
to be met in connection with installation.
Should further information be desired
or should particular problems arise
which are not sufficiently covered for the
purchaser's purpose, the matter
should be referred to the manufacturer.
Warranty
Warranty is based on the general terms
and conditions of Trane-Ingersoll
Rand. The warranty is void if the
equipment is repaired or modified
without the written approval of the
manufacturer, if the operating limits are
exceeded or if the control system or
the electrical wiring is modified.
Damage due to misuse, lack of
maintenance or failure to comply with
the manufacturer's instructions or
recommendations is not covered by the
warranty obligation.
Reception
On arrival, inspect the unit before
signing the delivery note. Specify any
damage on the delivery note, and send
a registered letter of protest to the last
carrier of the goods within 72 hours of
delivery. Notify the local Trane Sales
Office at the same time.
The unit should be totally inspected
within 15 days of delivery. If any
concealed damage is discovered, stop
unpacking the shipment.
Performance Data
Take photos of the damage material if
possible. Notify the carrier immediately
by phone and registered mail. Notify
the local Trane Sales
Concealed damage must be reported
within 15 days of delivery.
Check the unit nameplate to confirm
that the proper unit was shipped.
Available power supply must be
compatible with electrical characteristics
specified on component nameplates.
General Information
This manual covers the installation,
operation and maintenance of the Trane
WCVS.
Note:
"Warnings" and "Cautions" appear at
appropriate places in this manual. Your
personal safety and the proper
operation of this machine require that
you follow them carefully. The
manufacturer assumes no liability for
installations or servicing performed by
unqualified personnel.
Handling
The unit will be supplied with a
shipping base and
packaging over the unit casing. The
packaging should be kept on the unit
during handling or storage on site.
lf it is necessary to remove the packaging
for inspection prior to completion of on
site handling, retain packaging parts
and reapply them by tapping in position
(i)
to prevent damage to the casing. The
unit as supplied has a shipping base
which is suitable for handling by a fork
Office.
lift truck. If it is necessary to sling the
unit, use spreader bars under the
shipping base. Ensure that ropes do
not cause abrasion to the surface of
the unit.
protective
®
TRANE