Table of Contents
Advertisement
5. INPUT: Eight BNC connectors for connecting up to eight SDI displays using RG-6 or
RG-59 cables (available separately).
SDI CABLES
SDI cables are constructed using RG-6 or RG-59 75-ohm coaxial cable, terminated with BNC
connectors on each end.
INSTALLATION
Perform the following steps to connect the switch to your SDI input and output devices, as
well as a PC for automated control using the RS-232 serial interface.
1. Ensure that all devices you will be connecting are powered off and unplugged from
their power sources.
2. Plug one end of an SDI cable (available separately) into the SDI video input jack on an
SDI display or other SDI device, then plug the other end into one of the OUTPUT jacks
on the rear panel of the matrix. Repeat for up to seven additional SDI displays or other
output devices.
3. Plug one end of an SDI cable (available separately) into one of the INPUT jacks on the
rear panel of the matrix, then plug the other end into the SDI output jack on one of
your SDI video source devices. Repeat for up to seven other SDI video sources.
4. (Optional) Plug one end of an RS-232 serial cable (available separately) into the RS232
port on the rear panel of the matrix, then plug the other end into an RS-232 serial port
on your PC.
5. (Optional) Plug the included IR Receiver into the IR EXT jack on the rear panel of the
matrix, then position the IR "eye" where it can receive IR signals from the included IR
remote control.
6. Plug one end of the included AC power adapter into the DC 5V 3A jack on the matrix,
then plug the other end into a nearby AC power outlet.
7. Power on your display(s) or other device(s), then power on your SDI video source
device(s) and start playback of your audio/video source(s). Use the controls to verify
that all inputs can be seen on all outputs.
5
Advertisement
Table of Contents
