Husqvarna MADSAW 525iDEPS Operator's Manual page 24

each third operation that you sharpen the
cutting teeth.
We recommend that you use our depth gauge
tool to receive the correct depth gauge setting
and bevel for the depth gauge.
1. Use a flat file and a depth gauge tool to
adjust the depth gauge setting. Only use
Husqvarna depth gauge tool to get the
correct depth gauge setting and bevel for
the depth gauge.
2. Put the depth gauge tool on the saw chain.
Note:
See the package of the depth
gauge tool for more information about how
to use the tool.
3. Use the flat file to remove the part of
the depth gauge that extends through the
depth gauge tool.
To tension the chain
WARNING:
incorrect tension can derail from the
guide bar and cause serious injury
or death.
A saw chain becomes longer when you use it.
Adjust the saw chain regularly.
1. Loosen the bar nut that hold the clutch
cover/chain brake. Use a combination
wrench.
24
A saw chain with an
2. Tighten the bar nuts by hand as tightly as
you can.
3. Lift the front of the guide bar and turn the
chain tensioning screw. Use a combination
wrench.
4. Tighten the saw chain until it is tight
against the guide bar but still can move
easily.
5. Tighten the bar nuts using the combination
wrench and lift the front of the guide bar at
the same time.
6. Make sure you can pull the saw chain
around freely by hand and that it does not
hang from the guide bar.
1744 - 004 - 22.03.2022