Download Print this page

JVC KV-MR9010 Instructions page 4

9-inch widescreen monitor

Advertisement

Changing the aspect ratio
You can select an appropriate aspect ratio for the playback video signals.
Basic procedure
/基本步驟
Each time you press the button, aspect ratio change.
ASPECT
Changeable aspect ratio
/可切換之縱橫比
When incoming 16:9 video signal
/當輸入
Pictures are fully shown on the
FULL:
screen.
• In some cases, the black bars
may be shown at the top and
bottom sides of the screen.
Pictures are reduced horizontally.
NORMAL:
• The black bars will be shown
at the left and right sides of the
screen.
• In some cases, the black bars
may be shown also at the top and
bottom sides of the screen.
The middle of pictures are reduced
JUST:
horizontally and the left and
right side of the picture enlarged
horizontally.
• In some cases, the black bars
may be shown at the top and
bottom sides of the screen.
Pictures are enlarged on the screen
ZOOM:
so that no black bars will be shown
on the screen. (The entire picture
cannot be shown on the screen.)
Maintenance
/保養
To prevent damage to the exterior
• Do not apply pesticides, benzine, thinner or other volatile substances to the monitor.
The cabinet surface primarily consists of plastic materials.
• Do not wipe with benzine, thinner or similar substances because this will results in discoloration or removal
of the paint.
• When a cloth with a cleansing chemical is used, follow the caution points.
– Do not leave the unit in contact with rubber or vinyl products for long periods of time.
– Do not use cleansers which have polishing granules because this could damage the cabinet.
Clean off dirt by wiping lightly with a soft cloth
When the cabinet is very dirty, wipe with a well-wrung cloth dipped in a kitchen cleanser (neutral) thinned by
water and then go over the same surface with a dry cloth.
(Since there is the possibility of water drops getting inside of the unit, do not directly apply cleanser to the
surface.)
Troubleshooting
/故障排除
What appears to be trouble is not always serious. Check the following points before calling a service center.
Symptoms
/症狀
• Colored spots (red, blue and green) appear on the screen.
• 帶顏色的斑點(紅色、藍色和綠色)在螢幕上出現。
• No picture appears and sound is not heard.
• 不出圖像亦聽不到聲音。
• The unit does not work at all.
• 本機完全不工作。
• Remote controller does not work.
• 遙控器失靈。
• Cordless headphones (not supplied) do not work.
• 無繩頭戴耳機(另購)失靈。
• Howling occurs from the speakers or the headphones.
• 揚聲器或耳機出現異常聲音。
Specifications
/規格
WIDESCREEN MONITOR
Screen:
9 inch liquid crystal panel
Number of pixel:
336 960 pixels (480 vertical × 234 horizontal × 3)
Drive method:
TFT (Thin Film Transistor) active matrix format
Cordless Audio:
Infrared audio transmitter (Support IR receiver
stereo headphones)
L-channel: 2.3 MHz
R-channel: 2.8 MHz
Effective listening angle: 30˚
Effective range: 2 m
Color system: NTSC/PAL
Input:
Video: RCA pin × 2 circuits
1 V(p-p), 75 Ω
Audio: RCA pin × 2 circuits
1.5 V(rms)
Output:
Video: RCA pin × 1 circuit
1 V(p-p), 75 Ω
Audio: RCA pin × 1 circuit
1.5 V(rms)
16:9
視頻信號時
圖像占滿螢幕。
• 在某些情況下可能會有黑欄出現
在螢幕頂部和底部。
圖像被橫向縮減。
• 黑欄將會出現在螢幕左部和右
部。
• 在某些情況下可能會有黑欄出現
在螢幕頂部和底部。
圖像的中部被橫向縮減,圖像的左
部和右部被橫向放大。
• 在某些情況下可能會有黑欄出現
在螢幕頂部和底部。
螢幕上的圖像被放大,因而不出現
黑欄。(圖像在螢幕上可能顯示不
全。)
Causes
/原因
This is a characteristic of liquid crystal panels and is not a malfunction.
此為液晶面板之特徵而非故障。
The cord is not connected correctly.
未正確連接導線。
Correct input mode is not selected.
未選擇正確的輸入模式。
The built-in microcomputer may have functioned incorrectly due to
noise, etc.
可能由於噪音等原因導致內置微處理器功能失常。
The battery has lost its charge.
電池電量已耗盡。
The sensor is exposed to strong light.
感應器暴曬於強光下。
It may be caused by a camcorder connected to the monitor.
可能是由於連接至顯示器的可攜式攝像機引起的。
GENERAL
Power requirement:
Operating voltage:
DC 14.4 V (11 V to 16 V allowance)
Grounding system: Negative ground
Allowable operating temperature:
0°C to +40°C
Allowable storage temperature:
–20°C to +80°C
Dimensions (W × H × D):
Installation Size (approx.):
250 mm × 49 mm × 374 mm
Mass (approx.):
2.4 kg (excluding accessories)
Design and specifications are subject to change
without notice.
切換縱橫比
您可以為播放視頻信號選擇合適的縱橫比。
您每次按該鍵縱橫比會依次切換。
When incoming 4:3 video signal
/當輸入
Pictures are enlarged horizontally
FULL:
and are fully shown on the screen.
Pictures are shown at the center of
NORMAL:
the screen.
• The black bars will be shown
at the left and right sides of the
screen.
Pictures are enlarged horizontally.
JUST:
The extensioni ratio increases
toward the both sides of the screen.
Pictures are enlarged on the screen
ZOOM:
so that no black bars will be shown
on the screen. (The entire picture
cannot be shown on the screen.)
如何避免損傷外表
• 切勿讓殺蟲劑,苯,稀釋劑或其他揮發性物質濺落到機器上。
機殼表面主要由塑料製成。
• 切勿以苯,稀釋劑或類似物擦拭機器,因為這些物質將導致機殼退色或掉漆。
• 當使用布沾上清潔劑擦拭機殼時,請注意以下幾點。
– 切勿讓機器長時間接觸橡膠或塑料製品。
– 切勿使用含有拋光顆粒的清潔濟,否則將損壞機殼。
請用軟布輕柔地擦去污垢
當機器髒污時,請用一軟布沾上以水稀釋過的廚房用清潔劑(中性)擦拭,然後再用乾布擦乾。
(因為水滴有可能會進入機體,所以請勿將清潔劑直接抹到機體表面。)
所出現的故障並非總是嚴重問題。在向維修中心求助之前請先檢查以下幾點。
Remedies
See "Note" on page 1.
請參閱第 1 頁上的"注意"。
Connect the cord correctly.
正確連接導線。
Select the correct input mode.
選擇正確的輸入模式。
Reset the unit (see page 2).
重設本機(參閱第 2 頁)。
Install a new battery.
安裝新電池。
Do not expose the sensor to strong light.
勿讓感應器暴曬於強光下。
Camcorder is now in recording mode. Deactivate the recording mode.
可攜式攝像機處於錄製模式。關閉錄製模式。
寬屏顯示器
螢幕:
9 英吋液晶面板
像素數:
336 960 像素(480 垂直 × 234 水平 × 3)
驅動方法:
TFT(薄膜發射器)有效矩陣電路制式
無繩音頻:
紅外線音頻發射器(支持紅外線接收機立體聲耳機)
左聲道:2.3 MHz
右聲道:2.8 MHz
有效視聽角度:30˚
有效範圍:2 m
顏色制式: NTSC/PAL
輸入:
視頻: RCA 針型 × 2 電路
1 V(p-p), 75 Ω
音頻: RCA 針型 × 2 電路
1.5 V(rms)
輸出:
視頻: RCA 針型
×
1 電路
1 V(p-p), 75 Ω
音頻: RCA 針型
×
1 電路
1.5 V(rms)
4
4:3
視頻信號時
圖像被橫向放大並占滿螢幕。
圖像顯示在螢幕的中央。
• 黑欄將會出現在螢幕左部和右
部。
圖像被橫向放大並占滿螢幕。其拉
伸比向螢幕兩邊擴展。
螢幕上的圖像被放大,因而不出現
黑欄。(圖像在螢幕上可能顯示不
全。)
/解決辦法
一般資訊
電源要求:
操作電壓:
直流 14.4 V(11 V 至 16 V 容限)
接地系統:負極接地
允許操作溫度:
0°C 至 +40°C
允許保存溫度:
–20°C 至 +80°C
體積(寬
×
×
深)
安裝尺寸(大約):
250 mm × 49 mm × 374 mm
重量(大約):
2.4 kg(不包括附件)
設計和規格若有變更恕不另行通知。

Advertisement

loading