Advertisement
FIT TO GRINDER
Hold
Hold the top of the Main Unit and tighten
the screws.
* Confirm NO tilt in Grinder.
* Adjust the angle of Grinder so as to make
the bottom surface flat.
* G13SB3/SE2 need [n] FOOT PLATE.
==>Refer to Page4.
WARNING
Make sure TORNADO is securely
attached, otherwise it may come loose,
causing injury.
BLADE INSTALLATION
Wrench
Blade
[m] Base Flange
[Requiring Spacer]
BOSCH
GWS8-115/GWS8-125
GWS9-125/GWS10-125
GWS11-125CI/GWS14-125CI
GWS15-125CIH(CIEH)(CITH)
[ k ] Spacer
T12.6
-2-
O K
O K
[a] Main Unit
Spindle
GWS6-115
G12SS
GWS7-115
[ j ] Spacer
T9.4
[r]
[q]
[d]
Wheel Nut direction
BOSCH
1. Loosen Knob Bolt and open [a] Main Unit.
2. Set the proper Spacer [h-k] into the Spindle.
3. Set [m] Base Flange on the Spacer.
4. Set the Blade on [m] Base Flange.
5. Set the Wheel Nut on the Blade.
(Be care of the direction of Wheel Nut)
6. Fix the spindle and tighten the Wheel Nut.
7. Confirm NO contact between the Blade and inner
area of the Main Unit.
Knob Bolt
HITACHI
G12SR3
G13SR3
[ i ] Spacer
T7.3
N G
* G13SB3/SE2 need
[n] FOOT PLATE.
N G
==>Refer to Page4.
BOSCH GWS6-115 / GWS7-115
After fitting, tighten [r] Setscrews into [d]
M-Connecter by [q] Wrench.
Do NOT over tighten [r] Set
screws or they could cause
damage or deformation to the
Grinder and Connecter.
OTHERS
G13SB3
G13SE2
[ h ] Spacer
T4.5
MAKITA
9554NB
9558NB
GA4530
9565CV
Advertisement
