Subscribe to Our Youtube Channel
Related Manuals for Server Eco BP-1
Summary of Contents for Server Eco BP-1
- Page 1 Eco Pump ™ MODEL: BP-1 Thank You for purchasing our Eco Pump™. This quality, NSF listed pump delivers precise portions and is a reliable alternative to the constant expense of disposable pumps. CONSISTENT PORTIONS—SERVE BETTER...
- Page 2 HEAD ASSEMBLY DISCHARGE TUBE PORTION CONTROL LOCKING COLLAR GAGING COLLAR is installed onto side of head assembly piston to control portion PISTON dispensed. Size engraved on gaging collar indicates portion size. SEAL 83005 PINCH VALVE SPRING FOOD EQUIPMENT LUBRICANT CYLINDER O-RING ASSEMBLY 11"...
- Page 3 Be aware of the product you are serving and the “Not acceptable for dispensing potentially temperature the product is required to maintain. hazardous foods.” Server Products, Inc. cannot be responsible for the serving of potentially hazardous product. DISASSEMBLY DISASSEMBLE AND WASH During disassembly, collect small parts in a container to prevent loss.
- Page 4 FLUSH & RINSE all pump surfaces with hot water. Use dishwashing soap, Place lower end of pump into container hot water of hot water and operate pump until all and nylon brush remaining product is expelled and only hot water is discharged. Pump is dishwasher safe.
- Page 5 CLEAN • Pump out all (if any) remaining food product from inside pump body. • Wash and rinse off outside of pump body. • Flush out and rinse inside of pump. • Place lower end of pump into container full of water and operate pump until all (if any) remaining product is expelled and only warm water flows from discharge tube.
- Page 6 PRACTICE SAFETY. WASH ALL PARTS PROPERLY BEFORE USE. See page 4. INSTALL SEAL onto head assembly piston. Apply small amount of food equipment lubricant inside seal. TIP: Side of seal marked “INSERT PISTON THIS SIDE” must face top of head assembly. Flared end of seal must face down.
-
Page 7: Prime Pump
ADD LID ONTO CYLINDER INSTALL HEAD ASSEMBLY INTO CYLINDER Apply a small amount of food equipment lubricant to the outside of seal. Slide locking collar down onto cylinder threading. Tighten firmly to secure head assembly to cylinder. INSERT PUMP into product container. PRIME PUMP Press pump several times until any air bubbles are eliminated and only product... -
Page 8: General Service
• Ensure that the stainless steel ball is snapped in place below tabs. SERVER PRODUCTS GENERAL SERVICE, Before sending any item to Server Products for service, repair, or return, contact Server Products customer service to request a Return Authorization Number. Merchandise must be sent to Server Products with this number.
Need help?
Do you have a question about the Eco BP-1 and is the answer not in the manual?
Questions and answers