Polaris Outlaw 110 2022 Owner's Manual page 161

FOG THE ENGINE
1. Treat the fuel system with Polaris Carbon
Clean. Follow the instructions on the
container. Start the engine. Allow it to idle for
several minutes so the Carbon Clean reaches
the injectors. Stop the engine.
2. Remove the spark plug and add 2-3
tablespoons of engine oil. To access the plug
hole, use a section of clear 1/4" hose and a
small plastic squeeze bottle filled with the pre-
measured amount of oil.
3. Reinstall the spark plug. Torque to
specification. See page 123.
4. Apply dielectric grease to the inside of the
spark plug cap. Do not reinstall the cap onto
the plug at this step.
5. Turn the engine over several times. Oil will be
forced in and around the piston rings and ring
lands, coating the cylinder with a protective
film of fresh oil.
6. If Polaris fuel system additive is not used, fuel
tank, fuel lines, and injectors should be
completely drained of gasoline.
7. Reinstall the spark plug cap to the spark plug.
ENGINE OIL
Change the oil. See page 119.
AIR FILTER / AIR BOX
Inspect and clean (or replace) the pre-cleaner
and air filter. Clean the air box. Drain the
sediment tube.
MAINTENANCE
159