Polaris Outlaw 110 2022 Owner's Manual page 148

MAINTENANCE
WHEEL INSTALLATION
1. Lock the parking brake.
2. Place the wheel in the correct position on the
wheel hub. Be sure the valve stem is toward
the outside and rotation arrows on the tire
point toward forward rotation.
3. Install the wheel bolts
them.
4. Lower the vehicle to the ground.
5. Securely tighten the bolts to 22 ft. lbs. (30
Nm).
WHEEL HUB TIGHTENING
Front wheel bearing tightness and spindle nut
retention are critical component operations. All
service must be performed by your authorized
Polaris dealer or other qualified service facility.
146
q
and finger tighten
AXLE AND WHEEL NUTS
Do not service axle nuts that have a cotter pin
installed. Your Polaris dealer can assist.
LAMP LIGHT
REPLACEMENT
DAYTIME RUNNING LIGHTS (IF
EQUIPPED)
If the daytime running lights do not operate,
replace the lamps. It is recommended you install
replacement lamps obtained from your
authorized Polaris dealer.
1. Remove the front cover (OUTLAW only).
2. Disconnect the lights from the harness.
3. Remove the rubber cover from the back of the
light assembly.