Attachment - Honda BF30D Owner's Manual

When the outboard motor is installed
extremely low, the idle port may be
immersed and the engine may
become hard to start or may run
poorly. Check that the idle port is
high enough from the water level
when the engine is stopped with the
boat fully loaded.
If the outboard motor is installed too
high, that will cause ventilation.
Optimum installation height varies
with boat type and bottom shape.
Contact the boat manufacturer for
any special recommendations that are
unique to a specific model of boat.
If the transom needs to be modified
to accommodate the outboard motor,
contact the boat manufacturer and
follow their recommendations for
corrective action.

ATTACHMENT

ROPE CLAMP SCREW
(tiller handle type)
LOCK NUT
WASHER
LOCK
NUT
TRANSOM
BOARD MOUNTING HOLE
Attach the stern bracket to the boat
transom by tightening the clamp
screws.
Attach a rope from the boat to the
hole in the stern bracket. This will
help to prevent accidental loss of the
outboard motor.
You may further secure the outboard
motor by bolting the stern bracket to
the boat transom. Use the optional
mounting bolt and nut kit or other
good quality stainless steel bolts, nuts,
and washers. Apply silicone sealant
WASHER
to the bolt holes.
BOLT
WASHER
INSTALLATION
33