Manufacture Default; Setting Syntax - Holux GM-82 User Manual

Gps engine board

Hide thumbs Also See for GM-82:

Table of Contents

GM-82 User's manual

5.2 . Manufacturing Default:

Parameter

Input Protocol

Output Protocol

NMEA Binary

Baud Rate

4800

Parity None

None

Stop Bits

Data Bits

Datum:

WGS84.

Protocol

GGA, GSA, GSV, RMC or by demand.

Datum change syntax:

>DOS\Sirfprog /Fdataxx.dat –Px –Bx –Csh1

-Px: x is com port, 1= COM1 2 = COM2

-Bx: Baud rate, 4800, 9600, 19200 or 38400

Example:

Change Datum to WGS84,

Sirfprog /Fdata58.dat –P1 –B4800 –Csh1 <Entry>

After change datum, the new datum will keep in SRAM. If long time (more than 20 days) no power

supplied to GM82, user must resend datum to GM82 when power on.

5.2.2 Addition Software

SiRFdemo is the Evaluation Receiver configuration and monitoring software provided with the GM-82.

This software can be used to monitor real-time operation of the GM-82 Receiver, log data for analysis,

upload new software to the Receiver, and configure the Receiver operation. See setup.pdf for more

information on the use and operation of SiRFdemo software.

Com A

Com B

NMEA Binary

RTCM SC-104

None

9600

Table of Contents