Faraday 15220A Owner's Manual page 31

FOR 15220A AND 15240A FIRE ALARM SYSTEM CONTROL UNITS
DETECTOR MANUFACTURER
W/BASE DETECTOR
ORDER NO. W/ BASE
SYSTEM SENSOR, DIV. of PITWAY CORP.
9183 W/9185 2151 W/B110LP
9183 W/9448 2151 W/B116LP
9184 W/9185 1151 W/B110LP
9184 W/9448 1151 W/B116LP
9418 1100
9419 2100
9420 2100T
9447 W/9361 5451 W/B401B
9447 W/9364 5451 W/B401
9447 W/9424 5451 W/B406B
9421 W/9361 4451HT W/B401B
9421 W/9424 4451HT W/B406B
9421 W/9364 4451HT W/B401
Notes: 1.) For specific wiring and installation information read the instructions provided with each device.
2.) For initiating circuit specifications, see the 15220A wiring diagram or 15240A wiring diagram.
3.) These detector models may be mixed and matched as long as total maximum standby current does
not exceed 3.0 ma. per zone. The total number of detectors on an initiating circuit should not exceed 30.
4.) The control unit is not intended to handle more than one 2-wire detector in alarm, per zone.
5.) The activation of a manual pull station or any other contact device will prevent any 2-wire detector on the
same zone from remaining activated or from activating.
*6.) The Hochiki Smoke Detector models may be mixed on the same initiating circuit, but they must not be mixed
with any of the other manufacturer's detectors. The total number of detectors on an initiating circuit must not
exceed 30.
U.L. COMPATIBLE 2-WIRE SMOKE DETECTORS
(ZONE IDENTIFIER "C")
NUMBER OF
DETECTORS
PER CIRCUIT
firealarmresources.com
MAXIMUM
STANDBY
CURRENT
0-25 0.120ma.
0-25 0.120ma.
0-30 0.120ma.
0-30 0.120ma.
0-30 0.100ma.
0-30 0.100ma.
0-30 0.100ma.
0-25 0.120ma.
0-25 0.120ma.
0-25 0.120ma.
0-25 0.120ma.
0-25 0.120ma.
0-25 0.120ma.
III- 16
(Cont'd)
DETECTOR BASE
INENTIFIER IDENTIFIER
A A
A A
A A
A A
A —-
A —-
A —-
A A
A A
A A
A A
A A
A A