PRESONUS Studio 24c Owner's Manual page 7

2 Hookup
48 Volt Phantom Power. The Studio 24c provides 48V phantom power for the
microphoneinputs.Pressingthe48V buttonswitches phantompoweronandofffor
all microphone inputs; the button will illuminate in blue when phantom power is
available on the microphone preamplifiers.
48伏特Phantom电源。Studio 24c为麦克风输入提供48V幻像电源。按下48V按
钮，为所有麦克风输入开关幻像电源;当麦克风前置放大器上有幻像电源时，按
钮将显示蓝色。
WARNING: Phantom power is only required for condenser microphones and
can severelydamage some dynamic mics, especially ribbon mics.Therefore,
switch phantom power off when it is not required.Consultthe user documentation
that came with your microphone before engaging phantom power.
警告: 幻影功率只需要电容麦克风，并可能严重损坏一些动态麦克风，特别是带
状麦克风。因此，请在不需要时关闭虚拟电源开关。在使用幻影电源之前，请
参阅麦克风附带的用户文档。
XLR connector wiring for phantom power 幻影电源XLR连接器接线 :
Pin 1 = GND Pin 2 = +48V Pin 3 = +48V
InputMeters.TheseLED metersshow the input level ofthe analog inputs on your
Studio 24c. The red Clip LED will illuminate when your input signal reaches -0.5 dBFS.
At this level,the signal will begin to overload the analog-to-digital convertersand
exhibit signs of clipping. Use the gain controls to keep the signal below this level.
输入Meters。这些LED表显示Studio 24c上模拟输入的输入电平。当你的输入信
号达到-0.5 dBFS时，红色夹子LED会亮。在这个水平上，信号将开始使模数转
换器过载，并显示限幅迹象。使用增益控制来保持信号低于这个水平。
Output Meters. These meters display the signal level received from the first two
driver returns (Main Left/Right). These meters have the same range as the input
meters and display the signal level before the main output level control.
输出Meters。这些仪表显示从前两个司机返回的信号水平(主左/右)。这些仪
表具有与输入仪表相同的量程，并在主输出电平控制前显示信号电平。
Sync LED. This light indicates if your Studio 24c is in sync with your computer. When
no sync is available, this light will flash red.
LED同步。这盏灯指示你的 Studio 24c 是否与你的电脑同步。当没有同步可
用时，该灯将闪烁红色。
Studio 24c
5