Table of Contents
Advertisement
IMP OR TA N T !
ALL FREE STANDING DRAWER OR STACKED
UNITS MUST HAVE ANTI-TIP BRACKETS INSTALLED.
IMP OR TA N T E!
TOUS LES TIROIRS AUTOPORTANTS OU LES UNITÉS
EMPILÉES DOIVENT AVOIR DES SUPPORTS ANTI-
BASCULEMENT INSTALLÉS.
ANTI-TIP BR ACKE T INS TALL ATION
K I T C ON T EN T S
• 2 – Anti-Tip Brackets
• 4 – 3/16" x 2-1/4" Concrete Screws
• 4 – 12 x 2" Phillips Wood Screws
R EQUIR ED T O O L S
Required tools include (but may not be limited to) the
following:
• Floor Protector
• Tape Measure
• Marking Utensil
• 1/8" Drill Bit*
• Phillips Bit Driver or 1/4" Hex-Head Driver
• Drill
*Drill bit type will vary by flooring material.
C AU T ION – A L L F R EE S TA NDING D R AW ER
O R S TA CK ED UNI T S MU S T H AV E A N T I -T IP
BR A CK E T S IN S TA L L ED.
Install the anti-tip brackets before moving the unit into
its final operating position. Contact a qualified flooring
installer for the best procedure of drilling mounting
holes through your flooring material.
P R O CEDUR E
1. Place the unit on the floor protector.
2. Determine the final installation location of the unit.
Measure 27/32" (22 mm) inset from the sides
and either 27/32" from the back or 18-1/2"
(470 mm) from the front (measure does not
include the kickplate). See fig. 1.
TEC_TM_120 REV. B
I N S T A L L A T I O N
FIG. 1.
Top plan view of anti-tip bracket positioning.
FIG. 2.
Securely fasten the anti-tip brackets to the floor.
FIG. 3.
Be sure the rear leveling legs slide into the brackets.
02/02/2022
A DA HE I GH T IN STA L L GUID E
Anti-Tip Bracket (top view)
Back
22-3/16"
Front
27/32"
18-1/2"
Page 35 of 74
Advertisement
Table of Contents
