Graco MY RIDE 65 Instruction Manual page 81

Convertible car seat

Hide thumbs Also See for MY RIDE 65:

How to Lock Your Lap and Shoulder Vehicle Seat Belt

Sliding Latch Plate and Switchable

Retractor

A latchplate that slides freely on the belt webbing and

cannot, by itself, hold the belt snug around a car seat.

When installing the car seat, route the vehicle seat belt

through the proper belt path and buckle it in. Slowly

pull the shoulder belt all the way out to switch it to

locking mode. Then, as you pull the vehicle seat belt

tight, feed all the slack back into the retractor.

Grab the sides of the seat at the belt path and slide the

seat side-to-side and front-to-back. The seat should not

move more than 1" (2.5 cm).

Note: With the vehicle seat belt in this locking mode, all the tension is upwards in the shoulder belt. This may

start to tilt your car seat sideways. If this happens, use a locking clip instead of this switching the retractor.

See Sliding Latch Plate and ELR Retractor.